Separate names with a comma.
Some features disabled for guests. Register Today.
That would have been mind blowingly amazing if that was it, but sadly there is no continuity.
I actually started at 250ms, but dropped it after...
$0 - 10
$1 - 255
$2 - 0
$3 - 0
$4 - 0
$5 - 0
$6 - 0
$10 - 1
$11 - 0.020
$12 - 0.002
$13 - 0
$20 - 0
$21 - 1
$22 - 1
$23 - 0
$24 - 50.000
I'd say the greatest headache by far has been the software/electronics side. I switched from the Phoenix due to it constantly disconnecting, to a...
The tolerances are only as good as you build it.
Before anyone says that's expensive for what it is, it really isn't. Custom work is always a bit more for a few factors. 1) Custom doesn't fit...
What I do it a 0.5mm pass as fast as it can without bogging down, then a lighter 0.2mm skim. If the load is too high, the Z axis will actually...
It's been available in black though.
Which axis is the flat spot aligned with? You more than likely have backlash.
I just use this 20/4 jacketed wire. It isn't shielded, but that hasn't shown to be an issue.
Yes, something is missing. Your control software has zero impact on anything. This is all decided in you CAM package. This "helix toolpath" is...
This escalated quickly. Go on. *grabs popcorn*
Your gantry is too tall. It's creating a fair amount of leverage.
Oooo, piece of candy! Now what to do with the remaining 99?
It's been a while since the last update.
Shout out to @Chris Laidlaw for making the z axis rail spacers. He'll more than likely be making more...
How do you plan to compensate for backlash?
An optical limit may not be the best idea consiy that there will be chips/dust flying around.
If you are absolutely dead set on this, check...
I would just replace the end plates with plates that accommodate a 45 degree. The is the easiest and cleanest solution. It's a printer, so you...
You can, but you should learn the ins and outs of 3 axis first.
Also make sure your couplers are actually attached firmly. Your electronic settings don't matter if the motor/lead is just spinning in the coupler.
It's been a while, but everything (minus the plates) is finally here.
A few simple mods were made to allow for both belt and direct drive. I'm...