Separate names with a comma.
Some features disabled for guests. Register Today.
Dropped voltage down to .45 so looking at just under an amp on the motors and they seem to run quite a bit cooler. Still pretty warm after a...
Upon reviewing the build guide for a Sphinx build I found that it calls out for 27mm screws which aren't available at OpenBuilds and thanks to...
[MEDIA] Hold on to your money for now. Initial results are worse than my generic A4988s, when the motors are running and stationary. The only...
I had this issue before but I can't for the life of me figure out how I fixed it last time this is to hold an Arduino board down, needs 4 3mm...
That worked perfectly! Thank you!
...that they’re in the process of repackaging the screws that hold down the spoiler board. Get them changed from sheet metal self tappers to wood...
He can borrow my kevlar apron :) 2+2=$.04
@eychei I've tried getting into the Boot loader using the same method as used on the Cube 2. I'd have to Google it again but it was something like...
They are steel tubing (the kind used for fencing) with custom end caps that we lathed down (from PVC pucks) to fit in the pipes and to hold a...
dougsnash published a new build: Read more about this build...
What about making the mounts out of plexiglass? I think they'll hold together long enough to mill some aluminium replacements...
...trimmed after the cut. I have a large router that uses a vacuum hold down but it has 3 very powerful 3 phase blow motors to pull down with. The...
I will add tabs!
+1 for an update. How's it holding up? Got a parts list or recommendations? I'm looking into outfitting an instrument used in a cotton gin with...
SBLabs, thanks for the update. My current thinking for cutting aluminum is to go with a hybrid of this and Giarc's recommendation, using the tape...
Nice rotary. Thank you much for posting STLs boutrous. I borrowed them to print the hold-down mechanism. I modified my "Low Budget Rotary" by...
Torque would equate to holding pressure, but if you're needing torque to hold the router down you might want to be a little less aggressive on...
ahh, eff it, I am buying a through shaft stepper and playing with this. what do you think of this? STP-MTR-17060D | Dual Shaft Stepper Motor: NEMA...
...machining job. I did sand the outside edge to remove the four hold down tabs I used to keep the piece in place while it was being cut out. No...
It really does need a spring loaded foot though, had a couple of accidents around the edges where it picks up the material and turns it back on...