Separate names with a comma.
Some features disabled for guests. Register Today.
Sweet build dcorb! You may want to swap those couplings out for the clamp style. I ripped some of those set screw types up recently...:rolleyes: I...
Also beware of the belt clamp screws dragging on the bar underneath if you tighten them down to far, this happened on my build and caused binding...
...- Can openbuild 24v circular LED lighting can magnetize the router clamp. isolate the led lighting of the clamp? I'm looking for all the...
...by the first picture above, wouldn't it be just easier to devise a clamp to go through the plate, directly into the centre gully with a tee...
I turned the vacuum off that's duct taped to the router and router clamp and the hose kinda lays over the top beam. Temporary until my dust boot...
Was there any chance the dust doe was hitting the work piece or clamp? I have had that happen and the z axis lost steps an the project got messed up.
...out radial free play and prevent whip by having two nuts - not to clamp. Your squaring approach is good enough - its not particularly...
...check the motor wire on the one that's lagging and make sure all the wires are on top of the clamp in the connecter and not under it as mine was.
What @Rick 2.0 said + if it's still stiff clamp it in the chuck of a battery drill and run it back and forth a few times. New nuts are...
That would be cool :cool:
Nice idea, I do not care for clamp / collar style pulleys so just ordered a new pulley. I might give this a go while I wait for it to get here....
...capabilities. Besides, tapping Delrin to a 3mm thread for the clamp screw would probably not hold. I think the commercial ones have a metal...
...explain to me how you made a closed loop out of your z-axis gt2 belt? A normal belt clamp wouldn't work with the belt running over the pulleys...
...the fume extractors simply tubes available from Home Depot? I notice that you have a bunch of 3d printed parts. Is the belt clamp in the skp file?
hi, Unless you can clamp your stock both sides of the blade and reduce the clearance around the cut, it's hard to get a clean one. Maybe you...
0 um hj j Hey Bob, Was wondering if you had tried that test anywhere else? For example under the x cross member, or under the z gantry plate....
...be made adjustable so that one edge of the plastic sheet is against the C-Beam? Your video showed the plastic sheet been held down by one clamp.
Mike Campbell published a new build: Read more about this build...
Love the build ❤️ Please add a video of her/him/it going And what clamp did you use to secure your mikita router looks fatter than the normal...
@rikkkk Please I like to know if the ER 20 spindle clamp ( as seen in @Colin Hart aliexpress.com attachment) work with Workbee or will I have to...