Separate names with a comma.
Some features disabled for guests. Register Today.
Hi David, Since the beginning of last year, when I purchased the blackbox, openbuilds limit switches and the XYZ probe, I have not had any...
That masks the problem rather than solving it. If you have a connection between mains EARTH and DC GROUND you have a potentially dangerous fault....
I have upgraded a nema 17 Machine with the black box, I’ve done it once before with the x4, this time the probe won’t work. I keep getting:...
it stops here, after z move up 5.06mm and triggers the limit switch even though it has just been homed. G0 Z7; move to z-safe height G0 F1000...
The Openbuilds Delrin (Black) v-wheels are 23.9mm in diameter. A quick look at Amazon and all the black Delrin wheels sold for 3D printers are...
Soft limits do nothing unless you have homing switches and homing is activated and working properly.
I saw this and was going to ask why there was a difference. I have designed my plates using the 99.7 mm between the top and bottom wheels because...
Using the Openbuild Blackbox X32 with the Openbuilds Software. Just put my CNC together and am attempting to mill my spoilboard. I am trying to...
...that setting them with that small of a pull off would trigger an Error 9 like I have been getting and that's why it was showing G) X19.939...
Did you follow ALL the setup steps in the BlackBox Documentation (Didn't perhaps skip section 7.1) during your initial setup? If you skipped...
...or invalid g code command found in block. (u see code) Error 9 g code locked out during alarm or jog state. 3 of these? (u see...
Good day folks, i recently bought and assembled a 1515 machine. i was in the process of doing a spoil board and it started running into an alarm...
...runs OK. With GRBL_HAL (freshly flashed from Control) I get 'error 9' as reported by @Niuulh (As an aside, I noticed that the probe status in...
...following file : "cnc.tap". But nothing happened. I could read error 9 upon the screen of the Offline Controller. Could you help please with...
Error 9 would come after some alarm. Probably alarmed because homing failed due to the motor not working Motor - from your video - looks like...
...standard way (Z is up, X is right Y is back)? You mentioned a error 9 and hard limit strikes in the deleted post. 3) If using Openbuilds...
There are several problems with that file. First line '%' shouldnt be there. Control will ignore it for you, but in general it shouldnt be...
Yes I have flashed 2 axis fw, although it has made no difference to the control gui. I can still move z axis (virtually), and I can still go to z...
...further, than it did the previous attempt, when it received an "Error 9 - Gcode locked out during alarm or jog state". At this point I...
Hi All, I have a problem: I am trying to surface a spoil board I purchased from SainSmart, which is the same size as the aluminum bed of the...
