Separate names with a comma.
Some features disabled for guests. Register Today.
I'm using a 0.8mm 2 flute down-cut to cut 1/16 balsa these days.. I like smaller bits for making tighter corners and less waste. all depends on...
Oh good question, Yes I did run from Estlcam (with the hardware flashed) but for laser I just searched and doesn't look well supported sorry.
I tried this once it was very easy.
I started out with an Uno and dq542ma drivers (worked perfectly well) but now I'm using a Backbox with Estlcam and using the firmware flash as...
Did you try increasing your current as well?
Lucky that steel has excellent creep resistance.. our plastic wheels on the other hand will get a flat spot.
Don't get me started on back emf!
Are you using a BlackBox? the current is set with the drivers not the software, on the Blackbox there are current adjust pots.
When you say...
Hi David, post your file you are using to get the circles, the drawing and the code if you can.
The current pots should be ~75% toward full if...
Depends on many factors, like your vacuum, the boot setup, the material. If you are cutting close to the material edge and there is a big leak...
Which post processor are you using?
Sure when a wire breaks or connector is loose, swap the wires between an axis to troubleshoot. If that doesn't do it swap the axis, if that...
Hello Dr. Did you remember to home and set your work zero? have to do that every time.
It still jogs in the correct directions I assume?
Hi Ronald, That's a normal sounding motor stall situation. Can be caused by some new friction such as your backlash nut being too tight or screw...
Looks solid! 3d printed blower?
The Granit was one I can think of, very stout.
Maybe not exactly what you are describing though.
Check out the builds area, there are many examples.
Did you reinstall the drivers?
docs:blackbox:install-drivers [OpenBuilds Documentation]
I think you will want to be able to V carve your text, look up the difference between 2D text and V carving.
The way I do it is SVG files from...
I've been using stepper cable like this one for 4 years with no issues. for the probe I replaced my lead with a 20awg silicone high strand very...
This will limit you to parallel/square cuts (nothing tapered), This is ok for your products?
That table design looks great!