Separate names with a comma.
Some features disabled for guests. Register Today.
what software tool chain are you using for your pictures?
OpenBuilds MultiStep Controller
CNC Dragon Rider
CNC Dragon Driver
(Above substituting "Flex" or "Open" for "Dragon")
Red Dragon Controller
(Or black, green, whatever)
OpenBuilds Flex Controller
Flex One Controller
Openbuilds CNC Box
Dragon One Controller
Control (the Openbuilds controller)
Control Freak (This might be in the list already since I didn't read the whole list)
I had to put my OX project on hold for about 6 months having already bought a lot of the materials I needed. Interestingly, I had...
I'm trying out your dual belt solution. I think I read somewhere one needs to seal the back of the rubber belt to make it stick well...
I was not planning on using a stepper because if I could get away with a reversible ac motor (driving two screws on either side of the lift) and a...
Yes, I was interested if the C-Beam or the belt driven methods could be used in any of my projects ... I was thinking of the lighter load ones ......
Yes, A scissor lift is the other way I am thinking of doing the 200lb project ... mainly because I'm having trouble finding a closed belt long...
The problem here is that I didn't state my initial question very well ... actually rereading its obvious that I'm asking wrong question ......
Ok I'll look at Unistrut ... I was just looking for a ballpark number or way to tell how much weight the screw or belt could hold ... I knew in...
Right ... I agree ... I'm not designing a CNC or 3d printer. I'm really looking into designing lifts for TVs or desks ... or for the 8mm screw...
Edit 11-5-15: just noticed I lost all the superscript formating ... just replaced with "^" ...
I did do a little math but I'm not 1000% sure I...
Anyone know what the max load is for the C-Beam Linear Actuator?
How about the other types?