Separate names with a comma.
Some features disabled for guests. Register Today.
Just converted my CNC laser over to use the the BlackBox motion control system, and so far, I really dig it! Super easy setup, and thus far has...
Hey Guys im just finishing up setting up a co2 laser and blackbox controller and have a quick question on the wiring. On the blackbox I am using...
Hi friends, I have searched the forums and writeups on how to specifically wire up the Blackbox to the K40 Power supply (24V, G, 5V, L) but I am...
Hello Forum! I have two very quick questions, and one medium length question. :) I have been trying to build a CO2 laser, and have had trouble...
Where to find? Building a co2 laser, I have x32 with stock firmware. I want to find firmware to setup a CoreXY system, I am not too familiar with...
This post is in some ways a way to reach out to the OpenBuilds team. After hundreds of hours with my Acro system, I'm sad to say, a 6-7W LED laser...
See my reply to your duplicate post here: Co2 Laser cutter/engraver using the OpenBuilds BlackBox
See Search Results for Query: Co2 blackbox wp th gnd | OpenBuilds
Yes, see Search Results for Query: Blackbox co2 laser | OpenBuilds
Thanks for your response but I didn't find it helpful. It still left me confused on what actually needs to be connected..
There are quite a few: =38']Search Results for Query: blackbox co2 | OpenBuilds Yes! Safest way! Easy Peasy :) : See Advice on CO2 Laser Build...
See 60w CO2 Laser BlackBox wire up and other threads here But basically: GND to GND PWM to TH Potentiometer wired between GND, 5V and IN (wiper...
Good Evening, Sir Good evening all, I need to know at what extent of power of CO2 laser can be used with Blackbox X32, like 80Watts, 100 watts,...
It would be best to contact the seller of the item for tech support for their product. Otherwise consider a BlackBox from...
Please excuse my ignorance but I am confused on "PWM to TH". What does the "TH" stand for? I am currently wiring up my K40 power supply to the...
K40s doesn't have a TH port, only an L port that needs an active low signal. The 60w+ ones has a proper PSU (info in this thread, does not apply...
Hi @Mark Carew, Thanx , waiting with anticipation :) really great community here. I Just build up an Acro 1510 with a 5.5w effective diode laser...
Hello everyone. I'm coming off using lightburn with a 7w laser diode to build a 90W co2 . I have a couple questions. I'm going to be using the...
Thank you for your answer! Sure goggles are on my list, wouldnt try anything without goggles. I will check if i can upgrade to grbl 1.1 and will...
Hi All, I know its an old post but I see that almost every other CO2 laser posts redirect here so I think its better to ask in this thread. I have...
