Separate names with a comma.
Some features disabled for guests. Register Today.
good day to all in the forum,
I have a cnd driven by the GRBL and I installed a 1,6 w LASER after having remove the Z motor.
I am searching for...
good day to all of you in the forum,
I have a GRBL ver 0.9J installed and works well on my three stepper motors machine.
I have now installed a...
could you please give me some more detail / procedure on how to use the program to achieve the painting ?
Thanks for all .
I have the following pens:2PCS CCL Anti-etching PCB circuit board Ink Marker Double Pen For DIY PCB
They resist well to my etching...
I am not an expert on those things: could you please give some more details on tools chain please ?
Any useful link ?
great GRBL !
I have my GRBL CNC working well.
Now I have coupled a PEN HOLDER having two springs directly on the Z axe with the intention to use...
thanks a lot Sonny for the explanation.
Now a lot of things are clear to me .
Hi to all in this forum,
I am still running v 0.9j; I have a question on the $5 "limit pins invert , bool ".
I am using Normally Open...
Let me attach the two different pin_out relevant to GRBL Arduino Nano.
there is a mistake in the pinout diagram in my hands.
D_10 is Y and D_9 is X limit !!!
>> Could someone post the correct pinout...
I have 5 Vdc on each of the board input switch and I have 0 Vdc when the switch is pushed.
On my schematics I have D_10 X_limit, D_9 Y_limit,...
I disconnected all the switch wiring from the board but still have the message: ALARM: Homing fail.
Thanks for all the assistance,
I did follow step by step the procedure. Now the Z is not activated at $H.
As soon as the X moves ( few millimeters...
I modified the config relevant to the v 0.9J but the Z still moves at the beginning of the homing cycle and then the fail message comes on.
Do I have just to " save" in wordpad ? How to create a file to send to Arduino please ?
Where should I have to connect the Laser ON...
It is me again:
This is my console reply...
Grbl 0.9j ['$' for help]
['$H'|'$X' to unlock]
$0=30 (step pulse, usec)...
I am trying to trobleshooting my system to remove the homing fail problem.
>> could you please indicate to me the procedue to remove...
I think the switches are wired ok: Y_limit is D_9: X_lim is pin D_10 and Z_limit is pin D_12 on my diagram.
PWM is working well.
I am very new to this GRBL.
I installed the gbrl 0.9j on my arduino board : all the motors are working properly and their limits work well if I do...