Separate names with a comma.
Some features disabled for guests. Register Today.
Yes i made a mistake with Chanel and start thread :) thank you very much :)
Peter i read in datasheet than there is 4 chanels but i think like you there is only one ( chanel is how many enter you have in screw for one...
how you found 1600 ? normally it's 200 4 circuits x 2mm = 8 mm pitch so 200*8/8 = 200 step/mm I think sfu is 4circuits x 4mm 16mm pitch so...
Hello, I have blackbox and i install sfu 1204 on my workbee 1010 I don't know what is the new settings for my firmware So I dont understand what...
I have to install post processor in local ? because i think when i stop fusion et start fusion it gets crushed
I change in the config post processor in fusion 360 and all work well :) thanks
It’s ok, firstly i think i can use m3 and sXxx. In my opinion my set up is most safely than only 0-10v to stop spindle. For fire i have near me...
I would like to know if it's possible to set M8 position before S24000 M3 in post processor fusion 360 blackbox ? Here code generated by post...
It's very complicated ! lol I will use contact in my coollant relay with Normal closed contact of my emergency stop i think. thank you for all
There is nothing about spindle dir in documentation ? Can you tel me about ? Sorry for this question but where version is writed ? Blackbox is in...
Thanks peter
In the blackbox can i consider that my ooznest probe is openbuilds probe ? in the other words it's the measure ? i found in ooznest website that...
I don’t understand There is link betWeen 0-10v and onboard relay ? How can i do ?
I don’t understand your answer. I don’t use pwm with relay. I have to shunt pin DCM and FORWARD on vfd to unlock it. That i would use the relay to...
I use blackbox with VFD controller, I would like to give startup permission to the VFD with blackbox's onboard relay. ( i'am not satisfied with...
I haven't plugged the Spindle yet, I'm in the process of installing it. I did the hardware configuration only but not software. I use a 40cm...
Yes $30=24000 and i have 10v when the vfd isn’t wired. The voltage drop only when connecting vfd. It is a huanyang 2,2kw
Hello, I set up 10v exactly with potentiometer in the blackbox ( i send m3 s24000). I would like to know it you have the measure beacause when i...
Thank you !
I réad documentation but i dont Understand how i can ajust the current perfectly. So, peter how would you do to get thé better of the high torque...
