Welcome to Our Community

Some features disabled for guests. Register Today.

Brass Numbers

Rating:
5/5,
  • Machine Type:
    OpenBuilds LEAD Machine
    Software:
    CMS IntelliCAD and CamBam
    Electronics:
    OpenBuilds BlackBox
    Feeds & Speeds:
    DOC - 0.020" - Feed 20 - Plunge 10 - RPM ~18K
    Materials:
    Brass
    Used the LEAD1515 to cut out a brass bezel and engine numbers for my 68 Camaro. Used some vinegar and salt solution to jump start the tarnish process. These are located on my grille.
    20220824_185508.jpg

Share this Project

User Comments

To post comments and download files, simply sign up and become a member!
  1. Isaac J
    How thick was the brass? And what speeds/feeds/endmill did you use? I've had mixed results cutting 0.09" brass and I can't tell what I'm doing wrong.
      Dale Newton likes this.
  2. Mark Carew
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice