Not sure on the 8byj-48 steppers, but when every I make a pen plotter I usually opt for the simple 2 axis EiBotBoard. Hope this helps - http://www.watterott.com/en/EiBotBoard
thanks on post processor as i'm qa newbie at this i find it daunting apart from rewriting the circuit board i'm trying to plot there must be a way to tell grbl every Z andZ-1 command (pen up Down etc)that Hpxx2 nc file can change to see M03 and M05 commands you have been a great help so far at least someone knows i trying
" there must be a way to tell grbl every Z andZ-1 command (pen up Down etc)that Hpxx2 nc file can change to see M03 and M05" Not sure if it can done in grbl but, since it is a text file you could always use a good text editor that can do replace and you should be able to replace all the Z to M.
This topic has grown into more of a discussion so please post your question here - http://www.openbuilds.com/forums/general-talk.40/
Use the help of the tens of thousands of great minds who frequent the OpenBuilds forums!
Apr 21, 2017
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Welcome to Our Community
Comments on Profile Post by Rego