Welcome to Our Community

Some features disabled for guests. Register Today.

Learning how to build

Discussion in 'CNC Mills/Routers' started by Twoods, Jun 15, 2020.

  1. Twoods

    Twoods New
    Builder

    Joined:
    May 14, 2019
    Messages:
    2
    Likes Received:
    3
    Twoods published a new build:

    Read more about this build...
     
  2. MaryD

    MaryD OpenBuilds Team

    Joined:
    Apr 13, 2016
    Messages:
    649
    Likes Received:
    639
    Is that a plasma attachment I see?
     
  3. Twoods

    Twoods New
    Builder

    Joined:
    May 14, 2019
    Messages:
    2
    Likes Received:
    3
    Yup. I refit it to run a small plasma cutter as well as a router. All I did was link the torch to the z axis lower limit to fire the torch. Then all that was left was setting the pierce timing in the plasma software. And the proper... ( translate to gcode software I forgot what it's called. The offline controller doesn't do arcs ) and I was all set
     
    Giarc likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice