Welcome to Our Community

Some features disabled for guests. Register Today.

Touch probe help needed

Discussion in 'Control Software' started by Rob Atha, Dec 30, 2019.

  1. Rob Atha

    Rob Atha New
    Builder

    Joined:
    Aug 19, 2018
    Messages:
    53
    Likes Received:
    7
    Hi all.

    Just wondering if someone could help me with this touch probe I purchased from Ooznest in the U.K. I’ve seen quite a few of these plates with through holes and apparently it’s used to set up the XY datum position but I’ve no idea how to set it up. Can anyone point me in the right direction please?
    806BA3E3-D4FA-4B0B-A6A0-E6E76625FF11.png
     
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    13,754
    Likes Received:
    4,070
    Seeing as its Ooznest, are you using Duet or a Grbl based controller (affects the reply sorry need to know)
     
  3. Alex Chambers

    Alex Chambers Master
    Moderator Builder

    Joined:
    Nov 1, 2018
    Messages:
    2,681
    Likes Received:
    1,321
    As @Peter Van Der Walt said, but also if Duet what version of the firmware - big changes recently.
    Alex.
     
  4. Rob Atha

    Rob Atha New
    Builder

    Joined:
    Aug 19, 2018
    Messages:
    53
    Likes Received:
    7
    I’m using the xpro v4 rather than the duet,
     
  5. Alex Chambers

    Alex Chambers Master
    Moderator Builder

    Joined:
    Nov 1, 2018
    Messages:
    2,681
    Likes Received:
    1,321
  6. Rob Atha

    Rob Atha New
    Builder

    Joined:
    Aug 19, 2018
    Messages:
    53
    Likes Received:
    7
    Thanks Alex. Will have a look
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice