Welcome to Our Community

Some features disabled for guests. Register Today.

motor speed help...

Discussion in 'General Talk' started by gibson, Dec 6, 2019.

  1. gibson

    gibson Well-Known
    Builder

    Joined:
    Jul 5, 2015
    Messages:
    185
    Likes Received:
    32
    hello every one i`am useing v-carve pro and my issue is my cut out says it will take 2 hours but it took 10 hours machine seems to be slow I`am useing ballscrew motors are nemo 23 ..i did the mach3 motro calibration every thang seems to be on target motors seem to be slow ...any help on ballscrew settings ...or advice...
     
  2. David the swarfer

    David the swarfer OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Aug 6, 2013
    Messages:
    3,238
    Likes Received:
    1,815
    Seems to me that your maximum machine speed is slower than the feedrate you gave to Vcarve.
    What are the actual numbers?
     
    sharmstr likes this.
  3. gibson

    gibson Well-Known
    Builder

    Joined:
    Jul 5, 2015
    Messages:
    185
    Likes Received:
    32
    ty very mush for your reply here is what it gives me hope this is what u need...
     

    Attached Files:

  4. David the swarfer

    David the swarfer OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Aug 6, 2013
    Messages:
    3,238
    Likes Received:
    1,815
    3 inches/sec is 4500mm/min (faster than my belt drive machine can do at this time)
    What are your settings for GRBL variable $110 $111 and $112? (openbuildsCONTROL|GRBL settings)
     
  5. gibson

    gibson Well-Known
    Builder

    Joined:
    Jul 5, 2015
    Messages:
    185
    Likes Received:
    32
    i`am running the chinness breakout board ....mach3 than v-carve
     
  6. David the swarfer

    David the swarfer OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Aug 6, 2013
    Messages:
    3,238
    Likes Received:
    1,815
    Then you need to look in the mach3 settings for the max rapid travel rates. If you don’t know where to look then check the manual, the mach3 forums, and google. I dont use mach3 so I don’t know where the setting is, only that it exists and needs to be checked to diagnose your problem.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice