Welcome to Our Community

Some features disabled for guests. Register Today.

Job continuation

Discussion in 'Control Software' started by William Harper, Sep 6, 2019.

  1. William Harper

    Builder

    Joined:
    Jan 30, 2017
    Messages:
    38
    Likes Received:
    5
    is there a way to continue a job after a hard stop with out having to start over?
     
  2. sharmstr

    sharmstr OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 23, 2018
    Messages:
    2,030
    Likes Received:
    1,428
    Not unless you know what line it stopped on. If you do, you can edit your gcode file to remove all the lines already processed, but you need to make sure you keep the header lines in there (like spindle on, etc).
     
    Peter Van Der Walt likes this.
  3. William Harper

    Builder

    Joined:
    Jan 30, 2017
    Messages:
    38
    Likes Received:
    5
    Got it. Thanks. What a pain in the you know what.
     
  4. David the swarfer

    David the swarfer OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Aug 6, 2013
    Messages:
    3,237
    Likes Received:
    1,814
    if you use bCNC as the GUI then you can untick the already processed sections of code in the editor. the unticked sections will not run when you start the job again.
     
    sharmstr likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice