Welcome to Our Community

Some features disabled for guests. Register Today.

W|W plasma 1500x1500 (floating head & z-axis)

Discussion in 'Laser Cutters' started by wojak, Feb 5, 2019.

  1. wojak

    wojak New
    Builder

    Joined:
    Jul 5, 2018
    Messages:
    20
    Likes Received:
    30
  2. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,742
    Likes Received:
    2,407
    Nice work @wojak from the looks of it this is going to be a great machine :thumbsup:Thank you for sharing
     
    wojak likes this.
  3. Tracy Ranson

    Tracy Ranson Well-Known
    Builder

    Joined:
    Nov 4, 2014
    Messages:
    88
    Likes Received:
    32
    What are your plans to control the height of the torch? I have built an OX to be used as a plasma cutter as well, I can't afford a THC so I am open to ideas for height control for the torch. Nice build by the way.
     
  4. wojak

    wojak New
    Builder

    Joined:
    Jul 5, 2018
    Messages:
    20
    Likes Received:
    30
    Thank you :)

    I am using MyPlasm CNC controller.

    [​IMG]


    It has THC built in, also software is included and creator is very helpful and active, so I think it was good deal.
    Proma-elektronika

    Later I will try it with other controllers, it is described here:
    Plasma THC - LinuxCNC

    Also Stefan Cymbaluk covered a little about it and thanks to him I found it:


    This was my first choice and I don't know any other solutions.

    EDIT:
    Maybe this solution will fit your needs:
    A very entry level Torch Height Control from cheap available parts
     
  5. mytechno3d

    mytechno3d Veteran
    Builder

    Joined:
    Dec 15, 2013
    Messages:
    108
    Likes Received:
    311
    Hello
    Really good job , i think i will modified my floating head and add your proximity sensor.
    I try to use some THC , but was not really happy with it .
    On small size ( my maximum cutting size is 1300x1300 ) , i prefer to do Z Zero every time the move is higher than 25 cm.
    It is done by my postprocessor in sheetcam . So my cutting height is good on all my cut .
    For my next table , i think i will try plasm cnc controler who seems to work really fine
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice