Welcome to Our Community

Some features disabled for guests. Register Today.

Help For My Printer!

Discussion in '3D printers' started by emir sahin, Mar 22, 2018.

  1. emir sahin

    Builder

    Joined:
    Mar 22, 2018
    Messages:
    2
    Likes Received:
    0
    Hello i want to make 3d printer (cherry 3d) with cnc shield but when i want to load code, i take error: board_ramps_14_efb what i need to write?
     
  2. evilc66

    evilc66 Journeyman
    Builder

    Joined:
    Jan 9, 2015
    Messages:
    392
    Likes Received:
    153
    Why would you want to use a CNC shield? It has no hardware to drive the extruder or bed heater or inputs for the thermistors. Sure, you could hack those features onto the shield, but a RAMPS board does all that for you.

    As for your error, I think you will need to provide more information, like what Arduino board you are using, version of firmware, etc...
     
  3. jhonsam

    jhonsam New
    Builder

    Joined:
    Aug 7, 2018
    Messages:
    1
    Likes Received:
    0
    USE RAMPS instead of using CNC shield, CNC is a thermistors device that provides heat which may damage your system... if still have an issue contact
    Fix HP Printer Error code messages
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice