Been going nowhere fast. Installed / uninstalled the drivers, rebooted and still can't clear the error message. Any suggestions greatly received. thanks Andrew
hi, just setting up for the first time and i'm stuck with the same problem Have you found the solution cheers pete sunday 24th sep
Is the controller actually attached to COM4 ? This message is the result of ugs not receiving a valid GRBL version string. What version of GRBL is on your controller? "GRBL has not finished booting." · Issue #116 · winder/Universal-G-Code-Sender · GitHub
thanks for the reply, i was getting in over my head in a new field. i stopped reloaded the adrino this time into libaries and not lib and it works fine. all motors work . tomorrow i have to sort out the wiring to the y axis stepper motors cheers pete
hey , for the time being I've found an alternative way. In my case The " GRBL PANEL" seems to be working till now (apart from a few usual hiccups) . About UGS , I'm still stuck. I'm guessing windows isn't installing the drivers properly. I need to check the driver installation again. Cheers Akash
