Welcome to Our Community

Some features disabled for guests. Register Today.

Which controller board

Discussion in 'Controller Boards' started by Shannon Jardine, Jan 11, 2017.

  1. Shannon Jardine

    Builder

    Joined:
    Sep 17, 2015
    Messages:
    22
    Likes Received:
    1
    Hello all. I am building a large Laser cut table. The frame work is built for the table and I should have it install in my shop next week. I have the extrusion as part of the table and will put the gantry on after the table is set up. It is now time to get the electronics set up. I do have a CNC xPRO V2 Controller Stepper Driver and was wondering if this is the controller I want or is there another solution I should look at. I have been looking at the tiny G and it seems pretty solid.

    The build thread has not been updated to my new table design. it is still a large table.
     
  2. RobertW

    RobertW New
    Builder

    Joined:
    Dec 3, 2016
    Messages:
    45
    Likes Received:
    7
    This will be more than capable as long as your stepper motors are rated for less than 1.75A RMS. More than that could fry the driver chips. I think most nema 17 and some nema 23 motors fall into this category
     
  3. Shannon Jardine

    Builder

    Joined:
    Sep 17, 2015
    Messages:
    22
    Likes Received:
    1
    Thanks for the reply. I am using Nema 23 motors so I will check the RMS
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice