Welcome to Our Community

Some features disabled for guests. Register Today.

OpenBuilds Promoveo Study Builds

Discussion in 'CNC Mills/Routers' started by Ronald van Arkel, Jul 6, 2016.

  1. gclayton

    gclayton New
    Builder

    Joined:
    Nov 3, 2016
    Messages:
    4
    Likes Received:
    0
    I really like the designs of the machines described here. I'm going to build this model promoveo_2016_0_6_512_side-jpg.17613 and have ordered most of the parts needed from OpenBuilds.

    I'm a little confused about the double belt system described in a few posts.

    Are there any diagrams available how this belt system is set up?
     
  2. Ronald van Arkel

    Staff Member Builder Resident Builder

    Joined:
    May 7, 2014
    Messages:
    472
    Likes Received:
    245
    Thank you @gclayton,

    The 1000mm wide model is indeed the best width to build. Make sure that the legs are the same length.

    Check out this link: OX CNC and the Everman drive system. First,... - Maker Store

    The SketchUp drawing is attached; it's not perfect but you can can build the machine a lot easier with that drawing.

    -Ronald

    EDIT: PM me you email address and I'll send it to you there, can't upload it here...
     
    #32 Ronald van Arkel, Nov 29, 2016
    Last edited: Nov 29, 2016
  3. gclayton

    gclayton New
    Builder

    Joined:
    Nov 3, 2016
    Messages:
    4
    Likes Received:
    0
    Thanks Ronald,
    I was able to view that link ok.
    Gil
     
  4. gclayton

    gclayton New
    Builder

    Joined:
    Nov 3, 2016
    Messages:
    4
    Likes Received:
    0
    Sorry, I can't seem to find a way to send you a PM.
     
  5. Ronald van Arkel

    Staff Member Builder Resident Builder

    Joined:
    May 7, 2014
    Messages:
    472
    Likes Received:
    245
    Just click on the envelope icon next to search, it should show "Conversations".
     
  6. gclayton

    gclayton New
    Builder

    Joined:
    Nov 3, 2016
    Messages:
    4
    Likes Received:
    0
    I tried that but get an error message that states that I cannot start a conversation with you as the participant.
     
  7. Ronald van Arkel

    Staff Member Builder Resident Builder

    Joined:
    May 7, 2014
    Messages:
    472
    Likes Received:
    245
    It's the spam setting on the site, you only have 4 posts and they are from today, that would explain it ;).

    PMed you...
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice