Welcome to Our Community

Some features disabled for guests. Register Today.

Ox Z Limit Switch location

Discussion in 'CNC Mills/Routers' started by Blades, Jul 7, 2016.

  1. Blades

    Blades New
    Builder

    Joined:
    May 24, 2016
    Messages:
    30
    Likes Received:
    12
    Didn't find ton of info on this so I figured I would just post this quick setup of a ZAxis limit switch. There might be other ways that are better but for lack of available extra resources and wanting to get the job done , this works great! Small piece of flat aluminum bar and a quick received_1299410610088162.jpeg received_1299410656754824.jpeg received_1299410736754816.jpeg received_1284209344941622.jpeg tapped hole did the trick.
    Thanks Chris, Mark and Amon!
     
  2. Blades

    Blades New
    Builder

    Joined:
    May 24, 2016
    Messages:
    30
    Likes Received:
    12
  3. Blades

    Blades New
    Builder

    Joined:
    May 24, 2016
    Messages:
    30
    Likes Received:
    12
    received_1284208964941660.jpeg received_1284209174941639.jpeg received_1284209238274966.jpeg received_1284209301608293.jpeg received_1284209328274957.jpeg cnc porn. Yay hahaa
     
    David the swarfer likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice