Hi, My xyz probe was working flawlessly until this afternoon... No led and signal anymore. I think I have checked everything: No loose wire I have changed all the connectros Pluged a limit switch in the probe port of the blackbox x32 and test on troubleshooting of control. Works fine A standard z probe works well Any idea of what could be the issue? Thanks
Its a very simple device. SIG = the magnet, GND = plate. Multimeter in continuity mode to check. When magnet touches plate, SIG = connected to GND. No active electronics in between. SIG literally wires to the magnet (directly) and GND wires to the plate, also directly.
