Welcome to Our Community

Some features disabled for guests. Register Today.

Eliminate Supports with some kind of foam

Discussion in 'Concepts and Ideas' started by BillEgge, Jul 27, 2022.

  1. BillEgge

    BillEgge New
    Builder

    Joined:
    Jul 26, 2022
    Messages:
    4
    Likes Received:
    0
    Sometimes I winder if the hot end can melt its way through styrophome but still leave some to act as support for what your priniting.
     
  2. David the swarfer

    David the swarfer OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Aug 6, 2013
    Messages:
    3,239
    Likes Received:
    1,815
    too hot I think, the foam will melt back far beyond what you want, hard to predict
     
  3. Rob Taylor

    Rob Taylor Master
    Builder

    Joined:
    Dec 15, 2013
    Messages:
    1,470
    Likes Received:
    746
    Yeah, the foam near where it touched contracts away from the tip as well- you can see this if you do foam sculpting with a soldering iron or hot knife. It's also incredibly toxic to be basically burning styrofoam in the shop, so not the best plan.

    I think some kind of monolithic support structure is a good idea, I've had the idea before as well- non-printed supports would allow some really wild structures at a whole range of scales. Not 100% sure what it would look like- a fine powder that gets layered in would probably get aerosolized by the moving head and require heavy vacuum for safety, and a liquid would likely distort parts through both heat conduction and wave propagation from the moving parts.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice