Welcome to Our Community

Some features disabled for guests. Register Today.

Question about OpenBuild's stepper motor wires...

Discussion in 'General Electronics' started by Tony LaBelle, May 11, 2022.

  1. Tony LaBelle

    Builder

    Joined:
    Nov 27, 2015
    Messages:
    54
    Likes Received:
    6
    Hello All - The stepper motors I've received from OB have a pin connector on each wire then connected into the black connectors for interface...what is the name of the pin connector. I would like to use them rather than tinning each wire then installing into black connector. Is there a dedicated tool crimper for this type of connector? Thanks in advance for the help!!! Tony
     
  2. sharmstr

    sharmstr OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 23, 2018
    Messages:
    2,030
    Likes Received:
    1,428
  3. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    13,753
    Likes Received:
    4,070
    Check on amazon etc for a "Ferrule Crimper Set" - you get nice little kits with the crimping tool and a sortainer of different sized ferrules

    613XAJfmQ8L._AC_SY580_.jpg
     
    #3 Peter Van Der Walt, May 12, 2022
    Last edited: May 12, 2022
    sharmstr likes this.
  4. Tony LaBelle

    Builder

    Joined:
    Nov 27, 2015
    Messages:
    54
    Likes Received:
    6
    Shawn / Peter Thanks for the response...Exactly what I'm looking for :thumbsup:
     
    Peter Van Der Walt likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice