Welcome to Our Community

Some features disabled for guests. Register Today.

snap-in zip-tie holders

Discussion in 'Suggestions' started by brickfrogger, Apr 18, 2021.

  1. brickfrogger

    Builder

    Joined:
    May 21, 2020
    Messages:
    2
    Likes Received:
    3
    You know what I mean. Plastic guy. You snap it into the v-slot track. Then you zip a tie to the attached loop. Better yet use a cross in place of a loop. Could tie in two axis that way. If this exists already that would be even better. Thanks!
     
    MaryD and sharmstr like this.
  2. sharmstr

    sharmstr OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 23, 2018
    Messages:
    2,030
    Likes Received:
    1,428
    There's quite a few stl's out in the wild if you have a 3D printer
     
    brickfrogger likes this.
  3. brickfrogger

    Builder

    Joined:
    May 21, 2020
    Messages:
    2
    Likes Received:
    3
    No doubt. For the smaller and tight fitting items I find something injection molded to be superior to anything I can crank out.
     
    sharmstr likes this.
  4. MaryD

    MaryD OpenBuilds Team

    Joined:
    Apr 13, 2016
    Messages:
    649
    Likes Received:
    639
    Rick 2.0 likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice