Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

crypt-cube

Discussion in '3D printers' started by crypt-tek, Mar 12, 2019.

crypt-cube

crypt-cube

Discussion in '3D printers' started by crypt-tek, Mar 12, 2019.

The crypt-cube is another project I've been working on off and on over the past year, unlike my previous built C3DO this is a much smaller built with a volume of 318mm x 240mm x 220mm. With this build my main focus is precision and speed.

crypt-cube core xy 3dprinter crypt-tek custom design DIY
  1. crypt-tek

    crypt-tek New
    Builder

    Joined:
    Nov 25, 2017
    Messages:
    14
    Likes Received:
    92
    crypt-tek published a new build:

    Read more about this build...
     
    #1 crypt-tek, Mar 12, 2019
  2. Tim Curtis

    Tim Curtis New
    Builder

    Joined:
    Oct 6, 2014
    Messages:
    12
    Likes Received:
    1
    Looking good!
     
    #2 Tim Curtis, Mar 20, 2019
  3. Rob Taylor

    Rob Taylor Master
    Builder

    Joined:
    Dec 15, 2013
    Messages:
    1,470
    Likes Received:
    746
    Oh, this is nice! What's the performance like? What software chain?

    Got any detail pics of the shoulder bolt system? Did you tap the hardened ballscrews?
     
    #3 Rob Taylor, Mar 21, 2019
  4. crypt-tek

    crypt-tek New
    Builder

    Joined:
    Nov 25, 2017
    Messages:
    14
    Likes Received:
    92
    I will post more pictures soon, undergoing extruder head reconstruction as we speak. Performance is good so far calibration cube 20x20x20 came out at around 20.01 - 20.02 each side as of right now. Upgrading the extruders to 2 Bondtech dual drive extruders because I was having issues with Nylon filaments. The hardened ballscrew on the Z axis is not tapped, it is just rotating on a bearing and thrust bearings with the pulley attached to the shaft via 2 set screws.
     
    #4 crypt-tek, Mar 21, 2019
    Mark Carew likes this.
  5. shanehooper

    shanehooper New
    Builder

    Joined:
    May 16, 2016
    Messages:
    6
    Likes Received:
    42
    Well done!
     
    #5 shanehooper, Feb 18, 2021

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice