Welcome to Our Community

Some features disabled for guests. Register Today.

Updated interface and my spindle powers up by its self.

Discussion in 'OpenBuilds Forum Help' started by Ryan Matthes, Jan 25, 2021.

  1. Ryan Matthes

    Builder

    Joined:
    Aug 18, 2019
    Messages:
    19
    Likes Received:
    1
    Hi I hope some one can help me with this. I updated the firmware for the interface. After doing that the plug to interface that goes to the black box stopped working I have to bend the cable just to get it to turn on and if I move it. The interface turns off. So I disconnected the interface and tried running the job through the black box again and now my spindle just turns on as soon as the black box powers up. I reflashed the black box and I made sure my settings are correct I don’t know why the spindle would just turn on as soon as it powers up. Does anyone know how to fix this?
     
  2. Ryan Matthes

    Builder

    Joined:
    Aug 18, 2019
    Messages:
    19
    Likes Received:
    1
    Hi I hope some one can help me with this. I updated the firmware for the interface. After doing that the plug to interface that goes to the black box stopped working I have to bend the cable just to get it to turn on and if I move it. The interface turns off. So I disconnected the interface and tried running the job through the black box again and now my spindle just turns on as soon as the black box powers up. I reflashed the black box and I made sure my settings are correct I don’t know why the spindle would just turn on as soon as it powers up. Does anyone know how to fix this?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice