Separate names with a comma.
Some features disabled for guests. Register Today.
I actually haven't worked on it since the last post - a combination of issues has help me up: most of my time was spent with a High School...
Today is the first time I have worked on it in over a month...Hopefully will be trying a calibration cube tonight... Anyway, I'm not sure this...
What type of filament did you print with? For instance, ABS can shrink by as much as 1% from the printed size. So if that was an ABS print, it...
http://www.robotdigg.com/category/21/Endless+Timing+Belt
Love your build - think you solved the gantry/pulley attachment problem in a much cleaner way than I did (though my design squeezes out a bit more...
Oh, I forgot to note that I hit my build size target! Tested mechanical movement limits were X:450mm, Y:402mm, and Z:400mm - not too shabby using...
No, they are from robotdigg. They are slightly smaller which was exactly what I needed with my idler arrangement and they are a lot cheaper -...
And, it's alive!!! Haven't printed yet but I'm almost there...
Here are some close-ups... [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Yes, this is a true CoreXY (http://www.corexy.com/theory.html). I have modified the belt layout slightly to relocate the XY steppers and allow...
Adam, Originally it really boiled down to cost (and part) minimization. But if I had it to do over again I would likely do 4 ballscrews. This...
Appreciate your concern and heads up! :thumbsup: I saw the links on the Kickstarter comment section and already ordered a 5V regulator to mod...
Almost there... It turned out the default Z home step rate was 2mm/s...and since I have a 2:1 gear ratio on my Z belts turning ACME lead screws...
Sort of yay...o_O It turned out the board was brain dead! :sleepy: Took forever to find a comm setup that it liked to upload firmware....got...
I got it wired up last night and was hoping to do some movement tests with my cheap MKS 1.2 board...however, though the board appears to...
