Separate names with a comma.
Some features disabled for guests. Register Today.
I use Makejuice G+
Hi @evilc66 happy to see you in this game ;)
I am working on a similar project, the uTopiaPrinter (when I had more time I would publish on...
It is the support, otherwise the part will not print well, you should remove it with a knife.
As you want, if the rods are cut to the proper length, adjustment holes are unnecessary.
Frustrated by the assembly time of a Prusa i3 (and its lack of rigidity), I started to draw a more stable frame.
The hidden purpose of this...
****, too long time I did not come here. Sorry for the lack of responsiveness, many projects and not enough time.
@Derick You must use the frame...
Tanks @Ariel Yahni,
I think a vertical version is possible with a suction table or other holding system, the worry is that the cut pieces will...
Well done @Kyo :thumbsup:
Very useful, thank you @Mark Carew .
It's always a pleasure @Mark Carew ;)
Cool for the redesign :)
For the extruder look this one : http://www.thingiverse.com/thing:512338
Hello @Ranvir Jatana, Tank you for your comment :)
For the belt i use classic GT2 and it is 6mm width ;)
As I said in the comments, it is...
@JustinTime I can, but I'm in Switzerland... Instead look if you can find nearest you :
Thank you guys :)
@lucdepauw thank you for the interest in the project, any help is gladly accepted.
For the pockets : 6mm (for 16mm MDF) and...
skarab published a new build:
Read more about this build...