Separate names with a comma.
Some features disabled for guests. Register Today.
Found after I setup my parameter as per your instruction 0-10 is now working using the tool option in the openbuilds control thank you
Can you put your Px setup and also your $$ config
thank you I will try, any Idea why my 0-10 volt stay the same even if I do M3 S500 Is there any special config tha has to be set to set 0-10...
Hello David thank you for your answer thiis my setup , [12:15:47] [ $$ ] $30=1000.000 ;Maximum spindle speed, RPM [12:15:47] [ $$ ] $31=0.000...
No I dont think so I put ferrite beads to all my motor, and also run all my switch cable in a shielded to ground cable , but only on one side! I...
Another proble Arise , the momment I start the job aand spindle start , I lost my connection try to reconnect but USB port is nbot found anymore....
did you solved your Issue ? , Because I have the same problem with my NVBBDL+ , I even try with the 0-10 Volt,, but no rsponse , I even with a...