Separate names with a comma.
Some features disabled for guests. Register Today.
That beam you refer to is actually a length of aluminium angle. It's purpose is to support the drag chain that holds the wiring for the stepper...
Some good software that I have been using for my laser engraver, both are free. I have tried quiet a few, but of them all I found that LaserWeb...
I built my laser engraver using just GRBL 1.1h and a Arduino nano. Very simple setup and very cheap. Works very good. GRBL 1.1 has laser settings...
OK, tested that M0 and it works fine on my machine. Thanks guys.
Thanks Rob & Alex, I will give it a try and see what happens.
I am not sure if this s the correct place to ask this question, but here goes. I have a question on using the latest GRBL 1.1h. I want to make a...
That is good to know, it makes things much easier. When I come back from overseas I will re-wire the limits. I need to get some more shielded...
I am using just micro switches for the limits, but I do have several proximity sensors that I could try and use. I also have some micro switches...
I disabled both homing and the hard limits and tested again. It is cutting OK with that setting, no alarm and cut OK. Need to adjust the speed a...
I tried using the CNC for the first time without the plasma connected at all. I just wanted to check the movements and also check the settings...
I have fitted more than a dozen ferrite cores on all the cables that I can attach to, including the USB cable from the computer (it has 4 ferrite...
I am having the same problem with my system. It is DIY nano based controller using GRBL 1.1h. I have EMI filters on the power in for the UPS and...
RegPye published a new build: The plasma CNC that I have built has a water table that measures 1350mm x 650mm. The water is flooded onto the cut...
I have been building a plasma cutter that runs on GRBL 1.1h and I was using a self designed controller. This controller worked fine until I...
