Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks so much for your help.
Thanks, I appreciate this info. The last diagram in the sticky post in this group titled electronics 101 shows a solution. But I don't like it...
Hi yes I think we get that. However knowing the spec of the relay pins V and A ratings a circuit using other components can be made to control...
Same problem for me. Does any one have a DIY solution and circuit and component diagram of something that has worked for them?
The iot switching relay is not really suitable for use in the UK. I can't believe an alternative is not available or even a simple ish DIY...
Thats great you have it working. I could not get stepconf to do the right thing with my limit switches so I had to tweak the files for that. Other...
Yes, I will post the INI files over the week end.
Hi. It's going very well. I have some fine tuning for each of the axes but no missed steps. I suspect missed steps are more to do with your driver...
I have a question for the ooznest ox people. What is the trick for fastening down the waste board? Would a couple of bolts into drop in t-nuts at...
Ryan, Thanks, that's perfect. I suspect max rate and acceleration are not Linux cnc specific anyway.
Hi All I have my ooznest ox built. The instructions were fantastic and I had less trouble building it than I did a gas Bbq. I'm very impressed....
Thanks everyone for your input. I ordered from the US a G540. Now to see if I can get my head round linuxcnc stepconf and how to slave the second...
Thanks for your advice. I look into those options. The UK reseller for the g540 charges 325 pounds for it. Has anyone in the UK bought direct from...
That's a good question. All in with power supply and controller, 200 GBP. Thanks, Ivan
