Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks
Sorry to not figure this out, but where is the calibration field?[IMG]
I have asked this over at Github and no answers, I have read everything and watched all of the videos and I still have a question. Bcnc appears...
Very nice for sure. Do you happen to be using Bcnc? If so, what are you putting in the blank spots in the Probe tab? I have the probe as you do...
I am surprised that there wasn't any help on this thread, but I'll post what I have ended up with. I placed switches at each axis extreme, wired...
I believe that you need the switches be wired parallel using the NO circuit. as for wire size 24/22 should be fine, there isn't much for current.
Total newbie here. I have an OpenBuild machine and am getting a Makita RT0701C. It comes with a 1/4" collet. Seems that getting an 1/8" collet...
I have a openbuild machine and the builder didn't add the limit switches. I've watched a video on this and have a couple of questions. To get...
Being a TOTAL newbie and watching every youtube that I can find, one thing that pops up to me, its difficult for a wizard to make a beginner...
Great videos. I have a openbuild machine and the builder didn't add the limit switches. I've watched your videos on this and have a couple of...
I duplicated Kyo's sample and tried it. While it worked, I realized that I need to pay attention to which tool is used and the depth that I tell...
I have been and will continue to watch You Tubes. There is a lot of good info, eventually it starts to make sense.
Ok, I apparently, was clicking in the wrong spot. I now have the code like you have. When loaded into CAMotics I see the "work" and the tool is...