Separate names with a comma.
Some features disabled for guests. Register Today.
i have just checked, its 5mm thick
I will check later, but it would be at least 5mm
At least the old stuff is not wasted, I have made my version of the stewmac true channel
I used supported rail but square rail would be better
All i wanted was a hobby machine that will do precise work, I do now, wish i never waisted my money on those silly wheels. However I have learnt a...
Its ok, the only thing i would have liked is it to run slower than 10000 rpm
Another test, I wound the speed up on the 4mm cut to 3.5m / min [MEDIA] [MEDIA]
i have just finished rebuilding my machine, i also cut a hole in ally for the first time, it cut it like butter 6mm bit cutting 3mm deep @...
I am only cutting at 1mm depth for each pass and about the same for the drilling
woods, mahogany walnut ash and maple, feed rates varied 1200mm /m for cleaning up edges and 50mm/m drilling holes i can't remember why they were...
Its not strong enough or accurate enough for aluminium, as for cutting wood, it can cut it but not quite the same every time, its only take a...
You are correct, its nowhere near capable
It would seem that videos on youtube, help you get your money back, well half of it, thats what i asked for
If you are going to buy from China, don't use this guy, linearmotionbearings2008 [MEDIA]
to make it worse, before i bought the machine i asked if it was strong enough to build guitars, and was told it would do it easily, not even close...
