Separate names with a comma.
Some features disabled for guests. Register Today.
PhotoSgt85 published a new build: This is a build still in the prototype stage. The initial design is being used to control a 4 axis sample...
This is a build still in the prototype stage. The initial design is being used to control a 4 axis sample change, but the PCBs when finalized...
12 lbs 1 oz
Figured since I took a swag at some signage I should post them up. These were cut on my CBeam XL. Not bad for a first go.
Just wanted to let you know I found out that they are called Phoenix connectors. I have a project I hope to have coming forth soon that uses these...
Mark, I was wondered if you could share where you sourced the green connectors on the APEX design that go from the PCB to the stepper driver. I...
If you are looking to get started with Arduino there are a plethora of videos on youtube. There is one guy who is quite helpful...
Done. Thanks!
So I got a little side tracked recently when I ran into the need for a 3D printer. I am building a delta style printer out of some 80/20...
PhotoSgt85 published a new build: A brief write up of the making of the FLSUN Delta Kit. This kit is based on an open source design. I had a need...
So in looking at the mechanics involved I have an idea for how to possible minimize this issue: flip the X axis carriage. If you take into account...
My problem is the eccentrics loosening. I've been working on a full redesign of the z but the issue is really those ecentrics. I hesitate to...
