Separate names with a comma.
Some features disabled for guests. Register Today.
That is a really tall gantry, are you experiencing any flexing in it
definitely upgrade the X gantry to 80x40, I already have the beams, just not the plates
I am planning on a new X gantry plate that may include extending the wheels across to the 40x20 beam which should be upgraded to a 60x20 for hat...
As soon as it warms up I will run a test piece and measure it / publish the results with pictures
I would like to add screws but cant afford to right now, so Ill be staying with the belts I have not upgraded the Motors or the Spindle so there...
I love the case for you control system. Awesome :)
very nice indeed, If its ok, I will take your X gantry plates design and modify for Belt Drive (Add back the Stepper mounts etc)
Yes you probably could quite easily, I would think all the cut outs are to reduce weight and as you can see, in my case it also allowed me to...
May I suggest you consider only bending the lexan 45 deg and leave a little more on it to still coveer the wheels, as this will cause the chips to...
One thing would add based on you pictures is an internal X plate to the Y gantry rails and up the wheels there to two rows as I have done on mine...
I have taken the plunge to go 80x40's pretty much everywhere but still use belts, I will be doubling up the belts though using the one on top of...
Based on the OX build I have expanded the size to 1500mm by 1500mm but all the parts are still the OpenBuild 80x20, 60x20 and 40x20 using as close...
Thanks, I appreciate the feedback and diagrams To confirm a few things Spacing between Extreme wheels on a 80x40 or 80x20 rail is 99.7mm as...
An interesting setup there, looks like your using an 80x40 C section in the front of your X axis and a 40x20 in the rear but have a set of wheels...
Unfortunatly this one does not include the actual thread in the model either. A nice model but slightly short of complete Thanks for the effort...
