Separate names with a comma.
Some features disabled for guests. Register Today.
I already have three pairs of belts. I will attach a double belt to the X and Y axis. If only the X axis?
I removed the pulley and put it back. Nothing helped. What came with the head was the same, 0.35 mm, but I couldn’t measure it. I think one and...
Has anyone changed stepper motor bearings? I think it's his fault that he gets stuck every now and then.
Of course, the motors are switched off and have no contact with the driver. .... You think that the problem is not in the engine, but in the GT3...
While I'm waiting for a new set of ramen, I decided to go back to just one ramen. But I noticed something similar. If you tighten the belt, its...
Of course, I know this, now I was going to install two belts with the above system, but as it turned out, one of the old belts will not fit, I...
hi Have you ever seen this GT3 timing pulley? The GT2 timing pulley is shown in the photo. I couldn't find the GT3 dual timing pulley anywhere....
To put it bluntly, these graphs are no big deal. Never helped me to straighten the vertical and the horizontal ...
The first thing I noticed was this one brackets problem. From the beginning, do not order, make a big mistake. I will definitely add. The holes...
[MEDIA]
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
One Years later :) [ATTACH] [ATTACH] [ATTACH][ATTACH]
My CNC "workbee" has recently started weirdly cutting. Initially, I blamed the router because the sound changed during cutting. It turned out...
If you remember correctly, 1500 GBP
Truly a problem. I managed to reinforce it with steel. But it is advisable to add another X-axis :(
