Separate names with a comma.
Some features disabled for guests. Register Today.
I desperately need one of these adapters on my 1500x1500 OOZnest for a newly purchased Makita router. I'll actually buy two of them! Cost is not...
After reading many posts on the Vectric forum about using "machine bed" for z-zero to cut a profile all the way through the wood, and not carving...
Turned out to be a bad Xpro board
Craig: After posting this same thread on the Vectric forum, someone on that site suggested the same solution. I also used a 4' spirit level to...
I'm cutting out shapes from 3/4" Baltic Birch (with a black laminate on the face) for my sculptures, and getting uneven depth of profile cuts from...
Ryan: I purchased by replacement board from the Open Builds Store in the United States as I needed to replace it rather quickly.
Well, after trying all the helpful suggestions that everyone posted, it looks like the circuit board was the source of the problem. I did examine...
Neo: Yes I have noticed the lights on the board when moving the gantry manually. I have done that when working in my PJ's and wearing wool socks...
Neo: I didn't know that! Very interesting. I usually don't move it manually, but it's not out of the realm of possibility that I may have done...
Ryan: I don't think it's a Vectric problem because the repeating lines of question marks start as soon as I open the command tab on USG. This is...
Neo: I do have a wire running from my metal spindle mount up through my dust extraction hose and terminating on a screw on my electrical outlet....
I've been using Vectric Cut2D Pro since I started and have cut many jobs without a problem. If it turns out to be a GRBL problem, what do you suggest?
Scotty: Great idea! I hadn't thought of that! I do have an exposed controller board. I gave it a try by gently blowing some air in the controller...
