Separate names with a comma.
Some features disabled for guests. Register Today.
ok:) you can use then black Melamine Panel and mask it and then paint with white paint
but if it´s white stain paint then no need to mask because...
Hi thanks :) i use Melamine White Panel like this and paint with black
this is the black stain i use and Melamine White Panel[IMG] [IMG]
Hi i was lazy i did just grind the nut so it does not hit the plate
Giarc that look´s very stable and much cheaper a great Idea
Hi i did buy them from chrisclub1 on ebay Angle Brackets for the OX CNC (seen at Openbuilds) and other rail projects | eBay
but you maby find...
Hi i have not yet test to cut soft metals
i have only done some halftone
but i think that spindle is perfect for this machine
the Y axis with the...
Size 1000mm x 1500mm
4 380 oz-in Nema 23 Stepper Motor, 1/4" Shaft from http://www.cncrouterparts.com
[ATTACH] [ATTACH] [ATTACH]
Hi i use Gecko G540 it´s all in one it have the controller + Stepper Motor Drivers
Thank you :)
Hi i did use
20 x 80 VSlot - 2 @ 1500mm
20 x 60 VSlot - 2 @ 1000mm (join it together with 3 Low Profile Screws M5 maby it was 60mm you can...
Thank you i use this software http://jasondorie.com/downloads/HalftonerV1.4.zip
this is his homepage CNC Software
Thanks for the link going to check it out :)
it´s Veneer i think and it´s 18mm thick
The spindle im going to get is this...
MattiasN published a new build:
My CNC project
Read more about this build...