Separate names with a comma.
Some features disabled for guests. Register Today.
The base of the main printer is 2mm thick, Stainless Steel plate..... Remind me never to do that again. ;-)
The printer is capable of printing bigger than 300mm but for it's role as a test mule, this 300mm glass will be fine.... A 300mm heater element is...
The lower 1000mm will be for storage of filament etc. And the whole thing is on wheels.
This was the trial fit of the ceiling. I wanted to have the electronics at the top of the printer, rather than close to the heat-bed.
The printer will be fully enclosed but here I have just trial fitted the front and rear panels. the sides and middle of the front will be see...
There is a WAN RJ45 at the rear, an RJ45 network interface which will be installed at the front and wifi.
There is plenty of room in the top compartment, for all the printer electronics.
The printer farms houses it's own network switch with wifi and 4 ports. There will be a Raspberry PI with 7inch touch screen and AstroPrint plus...
This photo shows the core frame assembly using 1000mm chromed rods, CNC Aluminium corner, 400mm Carbon rods with wires for the effector run...
