Separate names with a comma.
Some features disabled for guests. Register Today.
I'm using 2005.
This is an upgrade from a standard OX I built this winter.
Building dimensions 1000 x 1500
For the x-axis: HIWIN Linear Guide (HGR20 rail and...
If you use 1/2 inch ball screw, you get whip. 1/2 inch = 12.7 mm. I used 12mm ball screw on my OX. But because of the whip I upgraded mine to...
It should be included according to Assembly Instructions in documentation.
No. I use 2005 screws.
Woops. You were a bit faster than me Rick. :)
I think you will need two steppers for the y-axis. One on each side.
Ball Screws, End Support and HIWIN linear rails is from BST Automation at Aliexpress.
The Z Axis is from microcarve on e-bay.
Knut Bøje published a new build:
My OX cnc upgrade.
Read more about this build...
Here is a table saw fence system I have looked at.
Biesemeyer style fence.
Have you tried same cut counterclockwise?
Here you will find what you are looking for.
Exactly. On such wheels I think it's better with pressure from the outside in.