Separate names with a comma.
Some features disabled for guests. Register Today.
Actually, the issue I am referring to is where, in post #24 you indicated that, because the antenna is inside the case you need to ensure that the...
I use one of the touch plates sold by Blue Ox Solutions on EBay. I created macros for the 3 sizes of endmill that I use, since the X and Y offsets...
I noticed earlier in the forum that wifi connectivity can sometimes be an issue. Is this still the case? I am starting to shortlist some...
Let me start by saying that I've been using the software for a bit and it is my preferred tool for what it does. However I do have a question and...
When I first built my CBeam Machine I used a 0.25" router bit chucked into the router on the CBM and ran that over the spoil board at a constant...
Sprags, there is a good description of the issue in the thread "The best cutting and squaring method??" in "General Talk". It also goes into a...
I am using a particle board spoil board, so I use particle board screws on thicker pieces, but on thinner stuff like 6 mm plywood and lexan sheets...
I had noticed this as well. In my case it turned out that the eccentric spacers had slipped a bit. For now I've reset them and made sure that...
I didn't see the 0.125" plate between the spoil board and the V-Slot in the diagram, and was thinking about making sure that the wheels line up...
[ATTACH] Here is a graphic of what I had envisioned. It isn't the easiest to view (I wish I had done it with the spacers under the wheels being a...
I was looking at the graphic right at the top. In it you appear to have a piece of 2020 V-Slot attached to the underside of the support for the...
Dogmeat, as an update I've not yet got my setup cut; been busy with things for my wife. However I had another thought based on the graphic that...
Michael, I have a question regarding a design decision that was made for the board. Specifically the ATX power on and A-motor sources; why did...
I prefer to use a set or engineers square (but not a cheap combination square) rather than a level (or even the 3 - 4 - 5 measurements with a...
I had a look at the xPRO wiki and it appears that the spindle output of the V2 is 0 to 5V.
