Separate names with a comma.
Some features disabled for guests. Register Today.
Pek, a feature request if you have some time. Z motor mounts extended from frame to accommodate mgn12 rails? Also, X axis carriage with mgn12...
yep, understood, lower priority, thanks
For those scratch building instead of moving parts over, this are the X carriages I will be using to clear my Z motor couplers. Because I have...
yes, yours for full MK2 upgrade
half version?
No reason to design for the original. I have just seen many posting problems overtightening the stock U bolts and thought yours could be a good...
Pek, is there any reason the new Y bearing holder won't work on the stock MKS2?
Ways Covers :) I'll post a few pics once I clean it off today, been a work table but I need to cut some alum sheet.
Not a fan of openbuilds wheel bearings for CNC. I have a homebuilt CNC and used linear rails. I can see a problem with swarf and dust collecting...
Nice!
Parts are slowly arriving in for my Bear scratch build....parts all printed... Mitsumi bearings arrived and nice hardened and very straight rods...
Nice! Just voted. Everyone please vote, takes a second.
Ok, thanks for the detailed feedback, I'll search out good traditional bearings to install
Pek, are you happy using IGUS bearings?
Once the few extrusions arrive that I need I can start building. At that point I can test some placement of the full size Z motors with couplers....
