Separate names with a comma.
Some features disabled for guests. Register Today.
All my hopes where dashed when I learned that grlb (black box) isnt compatible with THC.. After using a plasma cutter for so long with THC and IHS...
I have a 1515 would there be any reason I could not put the plasma add on, on to it? Torch height control? will it have it? I have been waiting...
Well was able to cut my first ACM box for a product I plan to offer. Much easier getting a good result with a flat spoilboard specially when 0.1...
Thanks guys! Youre awesome as always!
Well good news... finished another hour long job. Now to try some real cuts
So for fun, disconnected the software and I just unplugged everything to make sure it’s all reset. starting new test now
I clicked save to firmware... I don’t think it’s asks me to reset, it just does it
Well ran 2 tests this morning both successful! YAY First Test - set up a surfacing job for my entire spoil board and air cut it with Vacuum off...
well yes I understand that... but as long as one is careful that the jobs will not crash, or not accidentally run the gantry in to the end stop,...
I can still run a home cycle... what’s really the need in turning it back on tho
I needed to get my spoilboard surfaced so I can run some jobs tomorrow. So I didn’t care how it got done, just that it got done lol. Yes it’s a...
Well I’m not sure what fixed for sure but I am fairly certain Alex’s recommendation was it... first I tried turning off hard limits, soft limits...
I am going to replace my cheap chinese endstops With the proper openbuilds ones with emi filters built in.
That being said I tried the surface job with out the vac and it still failed
