Separate names with a comma.
Some features disabled for guests. Register Today.
I have the Black Box and VCarve 10.504. Should I be using OpenBuild_inch.pp and what changed should I make to the post processor if any. thank for...
Yahoo! I figured it out I chose Workbee 1010 and it let me save to firmware Then I went back to Lead 1010 and saved Everything works including the...
This is what I get when I connect to BB [18:13:45] [ $$ ] ok [18:13:45] [ $I ] [VER:1.1g.20181112:LEADMACHINE1010] [18:13:46] [ $I ]...
I changed computers yesterday and everything worked. I don't know why that would have anything to do with the problem I was having. But now... for...
I am getting the exact same errors. This is what I did so far to resolve the problem without success I double-checked the wires to make sure the...
Thanks Peter and Alex
Yes, all 4 motors have their own connectors and all 4 failed on Y but not on the other 3 drivers. I was a computer tech for 6 years so I...
The jumper is in place
I disassembled the Black Box, all solder looked good, pins are all straight, no burn spots. Rechecked all connections on the motor wires. Ran all...
Thanks Guys, back to work
Hello everyone, I believe this is the first time I have posted here. I have an R7 with the Tinyg controller. Everything works great but I wanted...
