Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks for your help
Thanks or your quick reply, Would you know where I could find the sketchup drawings?
Some years ago I bought a big ox kit. I like it and have made lots of things with it. The plates that support the x rails and a stepper motor...
Yep, Dave came through again. My problem was that I didn't home first. Once I did that all the code worked perfect, I didn't need to change...
Yes I'm using the open builds blackbox. I've made the change by deleting the code and typing in the new code and then clicking the save button...
I have a program that has some problems. I've found a code that I think is wrong so I went intothe Gcode editor and changed it. It worked fine...
Thanks, it was a port problem.
Just had my hard drive changed and now open builds doesn't work. Uninstalled program and reloaded with no luck. This is the screen shot of the...
Thanks for that I'm going to try out the changes now.
I think I might have got it right this time.
Is this what is needed? 35 is the original drawing with the X starting point. I did not cut this out . I used the off set and enlarged it by 6mm...
I did the first2 pages, hope that's enough. Thanks