Separate names with a comma.
Some features disabled for guests. Register Today.
CONTROL or Interface?
and right here in the forum resources, stuff to read if you don't like videos. Home, Fusion360 and G53 Z moves How to 'Fake the home'
only works if your clearance height is larger than the mistake in the material thickness. I would regenerate the gcode with the correct thickness...
to prevent the galling you can - spray with kerosene or WD40 - rub wax candle into the groove after each pass, ready for the next pass - spray...
the OB post can do it too, you have to change a setting to enable YZ and XZ planes, off by default. CONTROL cannot display the vertical arcs so...
I just use whatever web calculator comes up in google when I search for it (-: (or the tools settings in Fusion360 which will calculate when you...
need to be throwing chips like at 0:57 in [MEDIA] but then he spoils it all by not vaccuming the chips out
inches. I get 4500mm/min feedrate for a 2 flute, 2200 for single flute , so 18000 rpm may be too high, or you can go for 0.0025" per tooth...
this means your emergency switch is not doing what it is supposed to do. The emergency stop MUST cut power to the router and laser and BB. After...
I would try something like 0.040" deep, 0.005" per tooth, 18000rpm you CAM can calculate a feedrate from the rpm and per tooth values
grblHAL on PiPico, I think that has enough pins for what you want.
both those types of endmill have trouble ejecting the chips, which is probably why it is jamming up and stalling. an upcut single flute is what...
plenty of suppliers in Australia, use the OB page to figure out what you want, then look for it in-country.
@Peter Van Der Walt
ok, power switch not working, and motors not powering up, and you did load a profile from CONTROL. I think it is time you contacted the store for...
