Separate names with a comma.
Some features disabled for guests. Register Today.
This build is based on the OX build that is located at http://www.openbuilds.com/builds/openbuilds-ox-cnc-machine.341/
I am substituting the...
I have been twisted up for a while on my stepper settings in LinuxCnc. I will post a little about them and the solutions.
Finally working on my build again after a long hiatus
I have only been running them for a few days. I haven't done any heavy work with them yet and can't really venture an opinion on how it will go...
My Nema 23's from cncrouters worked fine
I am interested to see how this size works out
Tomorrow I will try to make a video of the software setup
If you use the gecko g540 no other driver is necessary. I scrapped that board and forgot to remove it from the BOM.
What are you building?
Yuck....I didn't think of that Rubber leveling feet it is
I found this calculator under resources for the OX. Perhaps you could use it to check your math....
I have a steel cabinet that I am considering mounting the OX to. I am hoping to add rigidity. Does anyone have any experience with mounting the OX...
Your video doesn't show up
Working diligently on my first cnc router
Does anyone have a drawing of a mount for the Bosch colt router that doesn't use hose clamps? Heck as long as I am wishing, how about one with a...