Separate names with a comma.
Some features disabled for guests. Register Today.
I should have mentioned, I just replaced the bushings. In fact, now thinking about it, this didn't occur until after replacing them. I posted a...
Before the Seperator I never had the issue so I had no grounding prior. Now I have a copper wire in the hose through the separator and earth...
Following... Same issues, Lead1010, basic Black box, R11 router. Grounded Dust collection Replaced Brushes in Router Didn't start until adding a...
I'll give that a try.
As stated, already replaced with no change. But what I am more curious about is why one brush in worn 50% more than the other. Is one side of the...
I have suddenly encountered what I believe to be a Static EMI issue. I have been running my 1010 with the same setup w/dust collection for over 2...
Now I keep getting a Alert code 1, Hard limit trigger. happens randomly, nothing hitting the switches. I checked all the cables, look good as far...
I have the LEAD 1010 with the black box and the Interface. This past week I have a couple of Strang things happen. 1 - After running a file I...
Awsome, thanks
I am not understanding something here. Everything has been fine until today. Started the machine, homed all, secured my material, set X , Y, Z...
Yep, did all that. I think I tweaked the current limit up just a bit too much. I brought it back down and so far so good. It hasn't happened...
Yeah I figured it didn't measure the temp on the motors, but if the motor is hot then the driver most likely is also. Might be a short, bad motor,...
