Separate names with a comma.
Some features disabled for guests. Register Today.
The tile cutting bit in the Dremel section at Home Depot or Lowes works great still.
I personally use a smaller diameter bit though. Mine is a...
Yes, but I have yet to do this with mine.
1 pound, 12 ounces :D
Mine is still getting used and working good 6 yrs later...
I would build another 3d printer with it.
Good to hear you got it figured out. What Justin said was going to be my next thought, lol.
Post a pic of the bad board.
If you had it wired this way then the diodes were soldered incorrectly (they are one way like a check valve is in plumbing)....
Those are diodes and they will pop if you reverse the polarity going to the board.
Very Nice. I like how it's all enclosed.
I added it to the original Sketchup file under the other attachments. I hope that helps.
Yes I can.
Just disassemble it within Sketchup and lay the parts flat. That is all that was done with the rest of the parts in the sketchup file.